Adding additional 48100R-C Batteries
I recently added 4 more 48100R-C batteries to my existing string of 2 batteries. The 4th battery in the string does not show up on BMS, however the first three and the last 2 do show up. All 6 batteries have the run light flashing as per normal. These batteries are connected to a Sol-Ark 12KW inverter, and all switch settings and jumper configurations seem to be correct. I have tried restarting the system by turning off all battery breakers, waiting a few minutes and then turning them all on again, followed by pressing the red button on the master for 1 second. No change when I do this. Is there anything else I can try?
- 1 Reply
Hi William,
It seems like the mis use of different firmware of the 48100R
Joesph from Pytes has just reached this to you. You can check if you have receive his email.
Log in to reply.
